450 บาท |
FLOWERING
ฟลาวเวอร์ริ่ง สูตรสารอาหารไฮโดรโพนิคส์
สำหรับเพิ่มผลผลิต
พืชไม้ดอกไม้ผล
เป็นสูตรที่มีธาตุอาหารครบถ้วน และสมดุลธาตุและแร่ธาตุหายากในธรรมชาติ ทำให้ได้ผลผลิตที่มีคุณภาพสูงสุด โดยเฉเพาะการปลูกพืชในโรงเรือนทีใช้ไฟ HID MH LED
มีจำหน่าย 2 แบบคือ
ขนาดบรรจุ
1 กิโลกรัม
และ
5 กิโลกรัม
FLOWERING FORMULATION HYDROPONIC NUTRIENT
FLOWERING Formulation nutrients, now a part of the Evolution Solution line of precision nutrients and supplies, are a full-spectrum nutrient suitable for all types of hydroponic systems. Over 20 years of experience have made Flowering Formulation the Ultimate Performer. Scientifically formulated to stabilize pH including when being used under HID lighting, you can be sure that maximum uptake of the highest quality salts used in this formulation is always available to your plants. For optimum performance, Flowering Formulation also contains slow-breakdown silica clays and vitamins. Ask your favorite hydroponics dealer for information about the entire Evolution Solution family of precision nutrients and supplies for hydroponics
INSTRUCTIONS FOR FLOWERING 2 PART LIQUID STOCK SOLUTION A&B
When using electronic conductivity measuring equipment
The main nutrient holding tank for the system should be filled with clean, fresh water. stock solution should be equal quantities. (by volume) until the disered CF(EC, PPM) value is achieved, using the conductivity meter for measuring the growing strength nutrient well and start the recirculating pump. Do not pH correct for the first 24 hours. Store any unused stock solution out of direct sunlight when not using electronic conductivity measuring equipment
For plants requiring low light. Use 4 ml each of stock solution” A”&”B” to each liter of water in the system For plants requiring high light, use 6 ml each of stock solution “A”&B per liter of water in the system.. Mix the nutrient well and start the recirculating pump. Do not pH correct for the first 24 hours. Store any unused stock solution out of direct sunlight.
IMPORTANT: DO NOT EXCEED DOSE RATES. THE USE OF AN ELECTRONIC CONDUCTIVITY METER IS RECOMMENDED TO ENSURE OPTIMUM NUTRIENT STRENGTH OR OR THE STRONGER NUTRIENT SOLUTION IS DESIRED
All systems will need to toped up as nutrients are taken up also dumped up periodically and flushed with fresh water. The timing required to depend on system types tank size crops grown please contact your supplier for your individual requirements
pH CORRECTION
Adjust the value of the nutrient growing solution to 6.3 pH with evolution solution pH Raise (caustic potash) or pH Lower (Phosphoric acid) or equivalent. Full strength acid or alkali should be diluted To a minimum of 100part of water to one part acid or we recommend an initial dilution of 1000:1 to prevent overdose or precipitation problem. Systems will need to toped up as nutrients are taken up also dumped up periodically and flushed with fresh water. The timing required to depend on system types tank size crops grown please contact your supplier for your individual requirements
ANALYSIS |
FINAL SOLUTION |
PPM
|
NITROGENN |
21.5% |
428 |
PHOSPHOROUS |
6.3% |
125 |
POTASSIUM |
41.7% |
630 |
CALCIUM |
15.5% |
309 |
MAGNECIUM |
4.9% |
98 |
SULPHUR |
9.7% |
194 |
IRON |
3.0% |
5.9 |
MANGANESE |
0.1% |
2.3 |
BORON |
0.015% |
0.3 |
COPPER |
0.003% |
.06 |
ZINC |
0.003% |
.06 |
MOLYBDENUM |
0.003% |
0.003 |
CONDITION OF SALE
1. All goods supplied are made from high-grade material.
2. As no control can be exercised over storage, handling, mixing, weather ,plant or soil condition ,during or the alter application (and all of which may affect the performance of goods, No RESPONSIBILITY for or liability for any failure in performance, loss, damage, or injuries ,(Consequential or otherwise ) arising from such storage , mixing, application or use will be accepted under any circumstances whatsoever and the purchaser assumes all responsibility for the use of the product.
3. These conditions cannot be modified varied, or waived by our staff ‘distributors, or retailers, whatsoever and the purchaser assumes all responsibility for the use of the goods and such person shall be entitled to the benefit of clause 2
4. Minimum liability, Liability is limited to replacement of faulty goods only.